Brake cam rear BGM original suitable for all Vespa Largeframe engines. Perfect OEM quality as a high quality but low cost alternative to the original Piaggio part. CNC machined from high strength steel with burnished surface. Including pre-assembled O-rings.
MONTAGETIP: The shoulder in the middle of the shaft (between the O-rings) is already intended as a grease reservoir from the factory. Since the shaft is directly supported in the aluminum of the motor housing, it should always be installed with a grease pack, such as the lithium saponified grease we offer (7673778). Thus no water can penetrate between shaft and bore in the housing and effectively prevents contact corrosion.
TIP: Many older motors still use a short brake arm (length about 50mm). This can be replaced with the longer brake arm (65mm) of the later PX Lusso or 200cc models. Through the longer lever, the possible braking power increases significantly, the dosability decreases slightly.
