MOTO NOSTRA turn signals with dynamic driving light for the Vespa GTS.
The turn signals from MOTO NOSTRA have individually controlled LEDs and thus offer a fully dynamic driving light, as known from vehicles of the upper class (eg Audi A7). The light effect produced is very appealing and offers a pleasant change from conventional turn signals. As a further special feature, the front turn signals have a bright white daylight band in plasma optics. At the rear, the same technology is used as a position light.
SECURITY THROUGH TECHNOLOGY
This new technology increases the visibility at the rear in the dark and thus significantly improves the perception in road traffic. The bright LEDs in the turn signals are clearly visible even from a great distance. The driving light is also visually better detected than with a conventional turn signal.
READ
The tinted turn signals give an exclusive and classy appearance. When not in use, they are visually inconspicuous.
Upgraded taillights
The matching MOTO NOSTRA taillights (see accessories below) have exactly the same glass tint and an identical reflector design. They therefore harmonize very well with the turn signals and together form a very successful visual and technical upgrade of the vehicle rear.
Quality
A special concern for us was the quality and fit. Both is with the turn signals of MOTO NOSTRA at a very high level and thus a high-quality alternative to the Power 1 turn signals.
It is also so that the turn signals of Moto Nostra are always supplied with connection adapters. So there is no need to intervene in the wiring harness!
TÜV
The turn signals have of course a test mark and are approved for public road traffic (no TÜV registration required).
Available for front or rear in clear glass or black tinted and as a cost-effective complete set.
CONNECTOR & ADAPTER
The set is supplied with an adapter plug (BGM6606BL18). This extends the wiring to the tail light and at the same time takes the current for the non-standard position lights. The extension also allows the cables to be routed in the bead under the tail light.
Important note:
When converting from incandescent lamps to LEDs for the vehicle turn signals
may occur due to the different resistance values of the illuminants or the factory installed relays
under unfavorable circumstances errors.
To avoid this from the outset, use in case of doubt a flasher relay such as article MN6202 or BGM6202.
The product has a registration number valid within the territory of the European Union.
