Can-Bus resistor CBW1 for LED turn signals

Can-Bus resistor for accessory flashers

>This resistor provides a required electrical load for your vehicle which, if the dip switches are set correctly, will result in no error message in the cockpit for accessory flashers.

In addition, reliability is ensured. This means:
In case of a failure of the accessory indicators due to an electronic defect, an error message is immediately displayed in the cockpit.

It is possible to operate up to 2 channels, such as rear left indicators and rear right indicators.

The resistor can also be used on vehicles with original LED indicators equipment.

>The following resistance values can be set:
150 Ohm
170 Ohm
240 Ohm
300 Ohm
400 Ohm
600 Ohm
1200 Ohm

measured:
Width = 31mm (without brackets)
Width = 46mm (with brackets)
Length = 40mm

Cable length = 200mm with pins

Connections:
yellow = input channel 1 (+)
orange = output channel 1 (+)
blue = input channel 2 (+)
red = output channel 2 (+)
grey = input ground (-)
black = output ground (-)

scope of supply: 1 pcs