Voltage Tester DUSPOL for Hybrid Vehicles

Benning Voltage Tester DUSPOL® digital

• Digital True RMS voltage tester with resistance/frequency range to, for professional testing of DC and AC voltages as well as for phase and polarity testing with load connection.
• Suitable for high-voltage systems in hybrid vehicle technology, electrical engineering, industry, maintenance, service (troubleshooting), photovoltaic/wind turbines
• Tested and approved according to IEC/EN 61243-3 (DIN VDE 0682-401:2011-02), CAT IV 600 V resp. CAT III 1000 V
• Cable break detector (phase tester) for non-contact localisation of cable breaks on exposed and live cables - yellow flashing
• Vibration alarm in the test handle for reliable voltage detection
• High-impedance voltage test without pushbutton operation (direct indication)
• Load connection via pushbutton (low impedance test)
• Switchable load circuit, faulty measurements due to capacitive and inductive reactive voltages are excluded by deliberate load switching via push button
• Deliberate tripping of a 30 mA FI circuit breaker
• Optical and acoustic continuity test via buzzer and yellow LED
• Display of the rotating field direction with arrow direction
• Safe single-pole phase test
• Display illumination and precise illumination of the measuring point via white high power LED
• Shock-proof, dust-proof and jet-proof housing (robust with rubberised grip surface)
• LC display illumination automatically activated by light sensor
• Including 2 x 1.5 volt micro batteries (LR03/AAA) (voltage display from 50 V even with flat batteries!)

  Technical data:

  Display: LED / LCD

  LED display levels: 50, 120, 230, ≥ 400 volts AC / DC

  Low Volt range: 1.0 - 11.9 Volt

  Continuity test: yellow LED

  Rotary field test: green LED (right / left)

  Phase test: red LED

  Polarity test: LCD

  Load switching via push button: S = 550 mA (1000 VDC)

  Resistance measurement: 0.1 kΩ - 300 kΩ

  Diode test: 0.3 V - 2 V (LCD)

  Frequency measurement: 15 Hz - 1000 Hz

  Protection class: IP 65

  Overvoltage category: CAT IV 600 V / CAT III 1000 V

  *A commercially available multimeter may not be used by the workshop, even if it is suitable for up to 1,000 V. But why is that? Quite simply: operating errors are to be excluded. If the measurement of the voltage freedom would be done with

  If the measurement of the absence of voltage is carried out with an incorrectly set measuring range - i.e. current instead of voltage measurement - and, contrary to expectations, the high-voltage system is not de-energised, a very high current can flow in the 'current measurement' mode due to the low internal resistance of the device.

  current can flow.

  Manufacturer Nr.: EDE 4014651502635

  EAN: 4014651502635