DIRT REMOVER 500ML TWIN AIR

DIRT REMOVER Spray for Motorcycle Foam Filters

TwinAir - Dirt remover spray

Cleaning fluid for foam filters (does not corrode). Ideal for removing dirt or oil. For optimum air flow.

Does not harden or damage the filter like solvents or gasoline, for example.

Instructions for use:

Spray the filter over a large area until it is evenly covered. Then leave to work for 5 to 10 minutes so that the filter oil can separate / detach from the filter.

>>> It is best to wear disposable gloves! <<<

Carefully remove dirt particles.

Rinse the filter with warm soapy water until all dirt particles have been removed (repeat the process if necessary!).

Then rinse the filter with clean water to remove the soap residue.

To dry, place the filter on a paper towel or hang it up.

>>> Do not oil before the filter is 100% dry, otherwise moisture will be trapped! <<<

Manufacturer Nr.: Twin Air

EAN: 8720239724523

Signal word Danger

Hazard-determining components of labelling:

• Anionic surfactant
• disodium metasilicate

Hazard statements

• H315 Causes skin irritation.
• H318 Causes serious eye damage.

Precautionary statements

• P101 If medical advice is needed, have product container or label at hand.
• P102 Keep out of reach of children.
• P103 Read carefully and follow all instructions.
• P264 Wash thoroughly after handling.
• P280 Wear protective gloves / eye protection / face protection.
• P302+P352 IF ON SKIN: Wash with plenty of water.
• P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P310 Immediately call a POISON CENTER/doctor.
• P321 Specific treatment (see on this label).
• P362+P364 Take off contaminated clothing and wash it before reuse.
• P332+P313 If skin irritation occurs: Get medical advice/attention.