LSL Clamping block kit 28,6mm, for: YAMAHA MT-10 16-, silver

LSL Clamping block kit 28,6mm, YAMAHA MT-10 16-, silver

Yamaha MT-10 16-, í˜ 28.6 mm clamp kit, available in various colours

X-Bar clamping blocks (identification KM45) for 28,6 mm handlebars
suitable for the following vehicle:
Yamaha
MT-10 year of construction:
MT-10 year of construction:

material: aluminium
material treatment: anodized
fastening: to originalMounting points
offset: - 17 mm
Dimensions: 28.6 mm Clamping

Our model-specific X-Bar clamps are mounted at the original mounting points. So you can mount on many models withoriginal 22.2mm handlebars to mount an X-Bar handlebar.
For models with standard rubber mountings, this will be retained. Depending on the model the handlebar position changes from -50mm to +30mm, thevalue for your motorcycle is given under offset.

ACHTUNG IMPORTANT NOTE: Before conversion, please check that the vehicle intended for conversion is marked in the ABE attached here withFor each vehicle there are different requirements and conditions which make it possible to convert the clamps.
The model assignments of theLSL clamping blocks are tested for use with the standard control arm of the vehicle.
The additional use of an LSL accessory control arm is possible, but may be necessary due to a different shapeof the handlebars may require additional modifications to the vehicle (longer cables or cables).
Even the increase of the original handlebars can lead to additional modifications to the vehicleCheck whether the following conditions apply to your vehicle (-see ABE):
- Use permitted when using a compensating support for the triple clamp
- with 20 mm longerBrake line Use permissible
- with brake line 30 mm longer Use permissible
- with LSL instrument holder Use permissible

If this is not observed, the type approval forthe vehicle!

The following articles fit to this product: 28,6 mm handlebar X-Bar