LSL Handlebar Rise-Up 30mm,Monster, silver, handlebar rise

LSL Handlebar Rise-Up 30mm,Monster, silver, handlebar rise

Handlebar-Rise-Up 30mm,Monster, silver

LSL RiseUp 30 mm handlebar elevation, suitable for Ducati Monster
The use of milled spacers moves the handlebar position upwards. This gives you a much more upright and relaxed sitting position.
Simple increase in seat position, CNC machined from high quality aluminum, are built into the standard handlebar clamp.

Note: Parts Inspection in connection with LSL handlebars
Material: Aluminium
Material Handling: Anodized
Rear Offset: 16mm
Offset Top: 30mm
Fixing: for Ducati with 38mm hole spacing and 22,2mm handlebars, incl. TÜV Parts Inspection

Scope of Supply: 1 set, incl. fixing screws and parts inspection.
NOTE IMPORTANT NOTE:
Please check before the conversion whether the vehicle intended for the conversion is listed in the attached ABE!
For each vehicle there are different conditions and requirements that allow a conversion of the terminal blocks.

The model assignments of the LSL terminal blocks listed in the ABE are tested for use with the standard driver of the vehicle.
The additional use of an LSL accessory handlebar is possible, but may require additional modifications to the vehicle (longer wires or cables) due to a different shape of the handlebar.
The increase of the original handlebar may also result in additional modifications to the vehicle.

Check whether the following conditions apply to your vehicle (-see ABE):
- Use permitted when using a fork bridge compensation pad
- With 20 mm longer brake line Use permitted
- With 30 mm longer brake line Use permitted
- With LSL instrument holder Use permitted

Failure to observe these conditions will invalidate the operating permit for the vehicle!

The conversion should only be carried out by trained specialist personnel.