HIGHSIDER AKRON-RS, license plate holder universal type 3, without license plate light

HIGHSIDER AKRON-RS, license plate holder universal type 3, without license plate light

Adjustable universal license plate holder&ltbr&gt

HIGHSIDER AKRON-RS Universal license plate holder

You can not find a model-specific license plate holder for your motorcycle?
Then you will certainly find the universal HIGHSIDER license plate holder HIGHSIDER AKRON-RS.

Because of the variety of different designs is certainly one that fits your bike.

The license plate is made of sheet steel and 2 mm thick. The precise cutting is done by laser. After edging still follows the weather-resistant black powder coating.
Through the stepless adjustment you can bring the plate without drilling in the desired position. An additional locking screw ensures that the plate remains in the position you have chosen.

To prevent damage to cables, all sharp-edged feedthroughs are protected by a rubber membrane grommet.

The turn signal brackets of the HIGHSIDER AKRON-RS are adjustable in width and thus suitable for any type of accessory turn signals. This adjustment option allows you to adjust the position for+r your turn signals to the most different license plates. To allow mounting of the turn signals without separation from the wiring harness, the 8 mm holes are slotted to the side.

Also the position of the reflector you can adjust individually via a slider. Adaptation to the different designs of EU license plates is therefore no problem.

To screw the license plate securely and reduce vibration are included two rubber washers. Another rubber buffer supports the license plate on its underside.

Details:
- bracket available in many different designs
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting without cable separation
- infinitely adjustable reflector, E-tested
- suitable for European license plates
- infinitely adjustable angle of inclination
- additional screw for optimum position security
- easy fixation without further work steps (eg.B. Drilling)
- easy mounting of the license plate through slotted holes

Included in the scope of delivery of the HIGHSIDER AKRON-RS:
- Selected bracket with mounting parts
- HIGHSIDER AKRON-RS license plate mounting plate
- Adjustable turn signal holders
- E-tested reflector with adjustable holder
- Mounting instructions

Notes:
- For the original turn signals is optionally available in the accessories special turn signal holder.
- If side reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.