LSL MANTIS-RS license plate holder universal type 1, without license plate light

LSL MANTIS-RS license plate holder universal type 1, without license plate light

Adjustable universal license plate holder

LSL MANTIS-RS Universal license plate holder

Making good bikes perfect. Following this motto, LSL has developed the universal license plate holder LSL MANTIS-RS.

If you have not found a model-specific license plate holder for your bike, certainly fits one of the universal license plate holders.
The holders are available in many different designs, one will certainly fit your requirements.

The license plate is always made of 2 mm thick sheet steel, laser-cut, edged and weather-resistant black powder coated.
The fixation of the license plate in the correct position is done by an additional locking screw.

Against damage to the cables, sharp-edged bushings are protected with rubber membrane grommets.

The, adjustable in width, turn signal brackets of the LSL MANTIS-RS are suitable for any type of accessory turn signals. This adjustment option allows you to find the right position for your turn signals. Adapting to the most diverse EU license plates is therefore no problem. The mounting holes of the turn signals have a diameter of 8 mm and are slotted to the side. This allows the installation of the turn signals without disconnection from the wiring harness.

Also the slider for mounting the rear reflector is individually adjustable. Adaptation to the different designs of EU license plates is therefore no problem.

The two supplied rubber washers serve the vibration-reducing screw connection of the license plate. An additional rubber buffer supports the license plate on the underside.

Details:
- bracket available in many different designs
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting without cable separation
- infinitely adjustable reflector, E-approved
- suitable for European license plates
- infinitely adjustable tilt angle
- additional screw for optimum position security
- easy mounting of the license plate through slotted holes

The scope of delivery of the LSL MANTIS-RS includes:
- Selected bracket with mounting parts
- LSL MANTIS-RS license plate mounting plate
- Adjustable turn signal holders
- E-tested reflector with adjustable holder
- Mounting instructions

Notes:
- For the original turn signals is optionally available in the accessories special turn signal holder.
- If side reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.