Gasket set from Athena with all necessary flat gaskets for the engine as well as O-rings and felt rings for the intake manifold.
The following gaskets are made of sheet aluminum and are coated with a thin layer of rubber:
Engine housing gasket
Clutch cover gasket
Seal for the intake manifold
Seal for the brake anchor plate
The rubber layer replaces the sealant, which is therefore no longer required
If the motor housing is still dripping, it may be warped or crooked. A warped housing is caused by unevenly tightened housing screws. Ideally, the housing halves should be tightened evenly (crosswise) using a torque wrench. The maximum value here is 6-8NM according to Piaggio specifications.
Scope of delivery as shown in the product picture.
The following gaskets are made of sheet aluminum and are coated with a thin layer of rubber:
Engine housing gasket
Clutch cover gasket
Seal for the intake manifold
Seal for the brake anchor plate
The rubber layer replaces the sealant, which is therefore no longer required
If the motor housing is still dripping, it may be warped or crooked. A warped housing is caused by unevenly tightened housing screws. Ideally, the housing halves should be tightened evenly (crosswise) using a torque wrench. The maximum value here is 6-8NM according to Piaggio specifications.
Scope of delivery as shown in the product picture.
